rotary bonng/tapping/cutting special machine is short for digital program controlled lathe. It has the advantages of tapping/ tapping/ tapping/cutting special machine with good versatility, tapping/ tapping/ tapping/ tapping/cutting special machine with high machining efficiency. rotary bonng/tapping/cutting special machine is a kind of machine that uses CNC technology to tap /tapping/cutting special machine according to preprogrammed programs. It is composed of program carrier, input device, CNC unit, servo system, position feedback system and machine tool mechanical parts. rotary bonng/tapping/cutting special machine Machining parts on automatic rotary bonng/tapping/cutting special machine usually goes through the following steps:

1. According to the drawing and process plan of the machined parts, write the program list with the specified code and program format, and record it on the carrier;

2. Input the program on the program carrier into the CNC unit through the input device;

3. After processing the input program, the CNC unit sends signals to the servo system of each coordinate of the machine tool;

4. The servo system drives the moving parts of the machine tool according to the signal sent by the CNC unit, and controls the necessary auxiliary operations;

5. Drive the relative motion of the tool and the workpiece through the mechanical parts of the machine tool to process the required workpiece;

6. Check the rotary bonng/tapping/cutting special machine and feed back to the CNC unit through the feedback device to reduce the machining error. Of course, there is no detection and feedback system for rotary bonng/tapping/cutting special machine.

Under normal circumstances, the oil filter and filter should be cleaned every two months. In terms of achieving on-time, high quality and low cost production, the trigger probe provides more support than just tapping the workpiece, that is, directly checking the geometric accuracy of the machined workpiece with the rotary bonng/tapping/cutting special machine is equally valuable. Because, through this direct accuracy test, programming errors and tool defects can be quickly detected, as well as the adverse consequences of the processing process.

The ambient temperature of rotary bonng/tapping/cutting special machine is lower than 30 degrees and the relative temperature is less than 80%. In general, the CNC electric control box is equipped with an exhaust fan or chiller to keep the electronic components, especially the central processor, at a constant operating temperature or a small temperature difference. Excessive temperature and humidity will lead to reduced life of the control system components and lead to increased failure. The increase in temperature and humidity, the increase in dust will produce a bond in the integrated circuit board, and lead to short circuit.

rotary bonng/tapping/cutting special machine https://www.zjshuangzheng.com/Rotary-Table-Intelligent-Assembly-Machine.html